Parallel scribing tool. DSPIAE AT-PST
Parallel scribing tool.
AT-PST
New
Parallel scribing tool.
- Loosen the thumb screw in front block to open the pin hole
- Remove protective cap on scribing pin, put it throught the hole for required length, tighten the screw to loc
- Loosen the thumb screw on top of the caliper to slide it to required spacing, tighten the screw to lock
- Place the lower end of sliding block against the edge of parts then move caliper laterally to scribe
Consultas sobre este producto
Be the first to ask a question about this product!
16 other products in the same category:
Parallel scribing tool.